Whirlpool Appliances
The Whirlpool Appliances integrationIntegrations connect and integrate Home Assistant with your devices, services, and more. [Learn more] allows you to connect Whirlpool and Maytag appliances to Home Assistant.
Supported devices
The following appliances are confirmed to be working, but other models may also work.
Air conditioners:
- Whirlpool SPIW309A2WF
- Whirlpool SPIW312A2WF
- Whirlpool SPIW409A2WF
Washers:
- Whirlpool WTW6120HW2
- Whirlpool WTW8127LW1
- Maytag MHW8630HW0
Dryers:
- Whirlpool WGD8127LW3
Prerequisites
- Valid Whirlpool/Maytag account credentials.
- Registered appliances in the official Whirlpool/Maytag app.
Configuration
To add the Whirlpool Appliances hub to your Home Assistant instance, use this My button:
If the above My button doesn’t work, you can also perform the following steps manually:
-
Browse to your Home Assistant instance.
-
In the bottom right corner, select the
Add Integration button. -
From the list, select Whirlpool Appliances.
-
Follow the instructions on screen to complete the setup.
Supported functionality
This integrationIntegrations connect and integrate Home Assistant with your devices, services, and more. [Learn more] maps appliances to entities in Home Assistant. A single appliance may be represented by one or more entities.
Climate
The whirlpool climate platform integrates Whirlpool air conditioning systems into Home Assistant, allowing control of the appliance through the user interface. The current inside temperature is also displayed on the thermostat card.
The following actions are also available:
-
set_hvac_mode (
off,heat,cool,fan_only) - target temperature
- turn on/off
-
fan mode (
low,medium,high) -
swing mode (
off,horizontal)
Sensor
The whirlpool sensor platform integrates Whirlpool Washer and Dryer systems into Home Assistant, allowing views of the machine state, time remaining, and the “wash & go” tank fill status as sensors for each device.
Removing the integration
This integration follows standard integration removal. No extra steps are required.
To remove an integration instance from Home Assistant
- Go to Settings > Devices & services and select the integration card.
- From the list of devices, select the integration instance you want to remove.
- Next to the entry, select the three-dot
menu. Then, select Delete.