Twinkly
The Twinkly integrationIntegrations connect and integrate Home Assistant with your devices, services, and more. [Learn more] allows you to control Twinkly LED string from Home Assistant.
This integration can be used to:
- Turn your Twinklys on and off
- Adjust brightness
- Control static colors and effects
- Switch between operation modes (see explanation below)
Music mode is currently not supported.
Effects
For devices with software version > 2.7.1, you can also control the effects on your Twinklys.
The Twinkly devices do not initially have any effects stored locally. Effects must be added from the Twinkly application before they become visible in Home Assistant.
Make sure the latest firmware is installed on your Twinkly devices and add effects by apply-ing them from the Twinkly app.
Operation Modes
Modes can be switched using the select entity.
For most use cases, “Color”, “Movie” and “Playlist” modes are the most relevant.
Color Mode
- Displays a static color
- Controlled through the light entity
- Color can be set via RGB/RGBW
Movie Mode
- Plays effects previously uploaded through the Twinkly app
- Effects must be created and transferred to the device first using the app
- Effect selection is done through the light entity
Playlist Mode
- Sequential playback of multiple effects
- Playlist must be uploaded through the Twinkly app first
Off Mode
- Turns off the lighting
Demo Mode
- Shows predefined demo effects
- Primarily intended for presentation purposes
- Limited practical use
Unsupported Modes:
- Effect Mode: predefined effects built into the device. Alternatively, you can use Movie Mode
- RT (Real-Time): Live control of individual LEDs
- Music: Music-controlled light show
Configuration
To add the Twinkly device to your Home Assistant instance, use this My button:
Twinkly can be auto-discovered by Home Assistant. If an instance was found, it will be shown as Discovered. You can then set it up right away.
Manual configuration steps
If it wasn’t discovered automatically, don’t worry! You can set up a manual integration entry:
-
Browse to your Home Assistant instance.
-
In the bottom right corner, select the
Add Integration button. -
From the list, select Twinkly.
-
Follow the instructions on screen to complete the setup.
If configured using an IP address, on your router / DHCP, you should assign a static IP to your Twinkly device.
Removing the integration
Twinkly follows the standard removal steps in Home Assistant.
To remove an integration instance from Home Assistant
- Go to Settings > Devices & services and select the integration card.
- Next to the entry you want to remove, select the three dots
menu. Then, select Delete. - Depending on the integration, the entries are listed under one of the following headings:
- Devices
- Hubs
- Services
- Integration entries
- Depending on the integration, the entries are listed under one of the following headings:
- To confirm, select Delete.
- Home Assistant also deletes the devices and entities of the entry.
- If Home Assistant asks you to restart, restart Home Assistant.
- If Home Assistant asks whether to also delete the application credentials, select Remove or Keep.
- If you keep them, Home Assistant uses them automatically when you add the integration again.
- To delete them later, refer to Deleting application credentials.