SensorPush Cloud
Integrates SensorPush Cloud devices into Home Assistant.
Prerequisites
A G1 WiFi Gateway is required to use the Cloud API. To activate API access, log in to the Gateway Cloud Dashboard and agree to the terms of service.
Sensor entities (temperature, humidity, barometric pressure) will not be available to Home Assistant until you have activated the device with the SensorPush app on iOS or Android.
Supported devices
- HT1 Temperature and Humidity Smart Sensor
- HT.w Water-Resistant Temperature / Humidity Smart Sensor
- HTP.xw Extreme Accuracy Water-Resistant Temperature / Humidity / Barometric Pressure Smart Sensor
Configuration
To add the SensorPush Cloud hub to your Home Assistant instance, use this My button:
If the above My button doesn’t work, you can also perform the following steps manually:
-
Browse to your Home Assistant instance.
-
In the bottom right corner, select the
Add Integration button. -
From the list, select SensorPush Cloud.
-
Follow the instructions on screen to complete the setup.
Sensors
For each device, the following sensors are created:
| Sensor | Description |
|---|---|
altitude |
Measures the altitude. (disabled by default) |
atmospheric_pressure |
Measures the barometric pressure. (disabled by default) |
battery_voltage |
Measures the battery voltage. (disabled by default) |
dewpoint |
Measures the dew point. (disabled by default) |
humidity |
Measures the relative humidity. |
signal_strength |
Measures the Bluetooth signal strength. (disabled by default) |
temperature |
Measures the temperature. |
vapor_pressure |
Measures the vapor-pressure deficit. (disabled by default) |
Known limitations
-
atmospheric_pressureis not available on HT1 and HT.w series devices.
Removing the integration
This integration follows standard integration removal. No extra steps are required.
To remove an integration instance from Home Assistant
- Go to Settings > Devices & services and select the integration card.
- Next to the entry you want to remove, select the three dots
menu. Then, select Delete. - Depending on the integration, the entries are listed under one of the following headings:
- Devices
- Hubs
- Services
- Integration entries
- Depending on the integration, the entries are listed under one of the following headings:
- To confirm, select Delete.
- Home Assistant also deletes the devices and entities of the entry.
- If Home Assistant asks you to restart, restart Home Assistant.
- If Home Assistant asks whether to also delete the application credentials, select Remove or Keep.
- If you keep them, Home Assistant uses them automatically when you add the integration again.
- To delete them later, refer to Deleting application credentials.