D-Link Wi-Fi Smart Plugs
The D-Link Wi-Fi Smart Plugs integrationIntegrations connect and integrate Home Assistant with your devices, services, and more. [Learn more] allows you to control the state of your D-Link Wi-Fi Smart Plugs.
Configuration
To add the D-Link Wi-Fi Smart Plugs device to your Home Assistant instance, use this My button:
D-Link Wi-Fi Smart Plugs can be auto-discovered by Home Assistant. If an instance was found, it will be shown as Discovered. You can then set it up right away.
If it wasn’t discovered automatically, don’t worry! You can set up a manual integration entry:
-
Browse to your Home Assistant instance.
-
In the bottom right corner, select the
Add Integration button. -
From the list, select D-Link Wi-Fi Smart Plugs.
-
Follow the instructions on screen to complete the setup.
Supported devices
The following devices have been tested:
- DSP-W215
- DSP-W110
Password: The default password is the PIN included on the configuration card or on the back of the unit.
Use the legacy protocol in case the D-Link Wi-Fi Smart Plugs does not work. This enables limited support for legacy firmware protocols (Tested with v1.24, v1.26). Data such as power consumption will not be available. The temperature will also show a freezing level.
Supported functionality
The D-Link Wi-Fi Smart Plugs integrationIntegrations connect and integrate Home Assistant with your devices, services, and more. [Learn more] provides the following entities.
Switch
The integration creates a switch entity for each D-Link Wi-Fi Smart Plug.
The switch entity exposes the following attributes. These are not available when using the legacy protocol:
- Temperature: the plug’s internal temperature.
- Total consumption: total energy used, in kWh.
- Current consumption: current power draw, in W.